gEDA-user: Is there a basic tutorial: Schematic->Netlists->Spice?

[Stefan Salewski]

On Wed, 2009-07-15 at 13:56 -0700, Daniel B. Thurman wrote:
> Noob here!
> 
> I am trying to ramp up to speed, primarily in creating
> a schematic diagram, to generating netlists, so that
> I can begin with spice analysis.
> 
> I just to get my feet wet, I created a *simple* circuit
> consisting of a VAC source, a resistor, and a capacitor
> so that I can understand the process from start to finish.
> 
> I have started out using gschem in creating a schematic
> as follows:
> 
> V1 = 100VAC
> C1 = 100UF
> R1 = 100K
> 
> But I could not figure out what to do next in generating
> a netlist using gschem at this point....
> 
> Is there a step-by-step tutorial around somewhere
> for the beginner?

Which spice?

For gnucap:

Very basic: 

http://www.johannes-bauer.com/electronics/

And gnucap documentation:

http://wiki.gnucap.org/dokuwiki/doku.php?id=gnucap:manual

You may find similar documents for ngspice.