gEDA-user: attach the net to the pin

[Stuart Brorson]

Yes, indeed.  Make sure your pins are *on* the grid.  If you made your
own symbols, make sure you have the grid set to something reasonable,
like 10.   And use the same grid setting in symbol edit mode as well
as in normal edit mode.

If you are using symbols obtained from some third person (the gEDA
distro or from gedasymbols.org), then make extra sure their pins like
on the grid.

Stuart


On Tue, 20 May 2008, Farrukh Aslam wrote:

> I had the same thing with obe of my own made symbols. But that was
> because I was not careful about the pin lengths while drawing my
> symbol. I always make sure all connections are snapped to the grid.
> Try clicking on the square and drag it to the net.
>
> On Tue, May 20, 2008 at 7:35 PM, François-Xavier Izenic
> <fx.izenic at gmail.com> wrote:
>> Hi,
>> I'm new to geda and i have this really lame problem in gschem : I can't
>> attach a net to a pin. I've tried many times, did big zooms on the red spot
>> of the pin, clicking in the middle of it. And still, i have the red square
>> mistake shown on the gscem warmup :
>> http://geda.seul.org/wiki/_detail/geda:warmup_gschem03.png?id=geda%3Agschem_warmup&cache=cache
>> Is there a way to do nets with a command line? Or any solution for my
>> problem?
>> Thanks,
>> FX
>>
>>
>>
>> _______________________________________________
>> geda-user mailing list
>> geda-user at moria.seul.org
>> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
>>
>>
>
>
> _______________________________________________
> geda-user mailing list
> geda-user at moria.seul.org
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
>