gEDA-user: close polygon

[Patrick Dupre]

Thank,

It does not change with "all directions".
The polygone looks like it autocloses but it stays activated. When I do
shift P, the polygone disappears. P removes the previous point.
Clicking right does not do anything.
Clicking the middle button reinitializes the polygon.


> On Wed, 07 May 2008 12:40:48 +0100, Patrick Dupre wrote:
>> This version 20080202
> This is fairly new. If I remember correctly, my problems with polygon closure happened in autumn. Your version should contain the fix.
> Sometimes it seems difficult to close a polygon if only 45° and 90° lines are allowed and a fine grid is chosen. Activate "All direction lines" in the settings menu to allow arbitrary angles. A coarse grid like 3mm helps, too.
> ---<(kaimartin)>----- Kai-Martin Knaakhttp://lilalaser.de/blog
>
>
> _______________________________________________geda-user mailing listgeda-user at moria.seul.orghttp://www.seul.org/cgi-bin/mailman/listinfo/geda-user
>

-- 
---
==========================================================================
  Patrick DUPRÉ                      |   |
  Department of Chemistry            |   |    Phone: (44)-(0)-1904-434384
  The University of York             |   |    Fax:   (44)-(0)-1904-432516
  Heslington                         |   |
  York YO10 5DD  United Kingdom      |   |    email: pd520 at york.ac.uk
==========================================================================