gEDA-user: PCB connections

[Ian Chapman]

I'm okay now, I set it to 0.008", thanks for all the help.  I am
planning to use http://www.4pcb.com/ Advanced Circuit's 4 layer, 30 sq
ins, 66$ special and they use 0.006" line/space unless any one has had a
bad experience with them?  They were fine on a low tech two layer
through hole board.  Regards Ian.

On Fri, 2008-04-25 at 13:22 -0400, DJ Delorie wrote:
> There is a GUI option.  For GTK, it's in file->preferences, in the
> lesstif version it's edit->board sizes.
> 
> Clearance should depend on your board fab's design rules.  For 8 mil
> spacing for example, you need 8 mil gap as well (it's spacing after
> all), so set your clearance accordingly.
> 
> 
> _______________________________________________
> geda-user mailing list
> geda-user at moria.seul.org
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user