gEDA-user: pcb printer calibration

[Anselmo]

Alle giovedì 29 novembre 2007, DJ Delorie ha scritto:
> 
> And if you just type "4" for both numbers, does it work?

No, i stil get 2
i got 2 for every number above 2.000

> 
> (also, you can type in the ratios if you calculate them yourself; the
> number it *wants* is a number very near 1.0, which it uses as a global
> scale factor)
> 

In fact that is wat i've done after your first email.

I think that the measure of all the segment, and not only of the bigger box, 
must be printed in the calibration page. To made the user able to check on 
the correctness of the data computed by pcb.
Even if the software is smart, probably it could be usefull to give a direct 
feedback to the user.
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: application/pgp-signature
Size: 189 bytes
Desc: This is a digitally signed message part.
Url : http://www.seul.org/pipermail/geda-user/attachments/20071129/54504def/attachment.pgp