gEDA-user: new boards!

[Mike Hansen]

Sorry if I missed this as part of the thread but once you did the brass 
stencil, what did you use to reflow the solder?  Hotplate, toaster oven, air 
pencil?


>From: DJ Delorie <dj at delorie.com>
>Reply-To: gEDA user mailing list <geda-user at moria.seul.org>
>To: gEDA user mailing list <geda-user at moria.seul.org>
>Subject: Re: gEDA-user: new boards!
>Date: 01 Mar 2007 00:13:31 -0500
>
>
>DJ Delorie <dj at delorie.com> writes:
> > http://www.delorie.com/house/furnace/pcb2/
>
>I just finished populating the first board, which will be the "debug"
>board.  The second one will end up in the furnace.  Note that the
>furnace one will have the RJ45 jack transplanted to the bottom edge.
>
>The brass stencil thing worked well enough.  There were only four
>bridges on the whole board, and only one of those was on the 0.5mm
>pitch connector, all easily fixed.
>
>I'm going to have to do something about the power supply, though - too
>much voltage being provided to the power module.  I've sent email to
>the manufacturer asking for advice.  Meanwhile, I haven't soldered
>those parts in yet.  I'm going to hook up a generic 5v supply for
>testing, probably next week as we're going to visit my in-laws for a
>couple of days.
>
>DJ
>
>
>_______________________________________________
>geda-user mailing list
>geda-user at moria.seul.org
>http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

_________________________________________________________________
Win a Zune™—make MSN® your homepage for your chance to win! 
http://homepage.msn.com/zune?icid=hmetagline