gEDA-user: schematic symbol text size for printing

[Ed & Angie S.]

Peter,

Yes, I see overbars in gschem also.  What I meant was that by using \_, the 
fact that the text size was not WYSIWYG (scaling factor not correct for 
postscript) didn't matter for overbars because the overbars would always 
match the text size for screen or print.  If graphical overbars are drawn, 
then matching the text size between screen and print was important because 
the overbars would be in the wrong place if the text size changed.  Or at 
least I think this is true.

Ed

----- Original Message ----- 
From: "Peter TB Brett" <peter at peter-b.co.uk>
To: "gEDA user mailing list" <geda-user at moria.seul.org>
Sent: Tuesday, June 05, 2007 3:21 AM
Subject: Re: gEDA-user: schematic symbol text size for printing


> On Monday 04 June 2007 21:08:49 Ed & Angie S. wrote:
>
>> Using \_xxx\_ to create overbars works great to eliminate the need for
>> WYSIWIG for overbars but it is still nice to see on the screen what you
>> will see in the printout.
>
> When I use \_ to create overbars, I do see overbars in gschem.
>
> Unless that's not what you meant, of course...
>
> Peter
>
> -- 
> Fisher Society                              http://tinyurl.com/o39w2
> CU Small-Bore Club                          http://tinyurl.com/mwrc9
>
>      09f911029d74e35bd84156c5635688c0            peter-b.co.uk
>
>
> _______________________________________________
> geda-user mailing list
> geda-user at moria.seul.org
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
>