gEDA-user: Bug in cvs pcb concerning polygons

[joe tarantino]

On 7/24/07, DJ Delorie <dj at delorie.com> wrote:
>
>
> >
> http://www-nw.uni-regensburg.de/~.grr06742.back.physik.uni-regensburg.de/PCB/GPS_BUG.PCB
>
> I reproduced it.
>
> > If I try to draw a copper rectangle on GND-comp it either doesn't
> > draw one at all or scrambles it in the lower left corner. Smaller
> > areas work fine though.  When zooming it sometimes appears again but
> > in the printout it's never right.  I get the messages :
>
> I've reported this before, but Harry hasn't offered a fix for it.
> He's the only one who really knows how the clipper works.
>
> With sufficient zooming/scrolling, you can make pcb segfault too.


I just ran into this same issue  when I was displaying a plane layer where a
polygon covers most of the board.  When there are a lot of perforations in
the polygon due to vias and pins I get a segfault after "sufficient"
scrolling.

Joe T

_______________________________________________
> geda-user mailing list
> geda-user at moria.seul.org
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.seul.org/pipermail/geda-user/attachments/20070724/67af5e3f/attachment.htm