gEDA-user: Panelizing methods?

[John Luciani]

On 2/1/07, Lares Moreau <lares.moreau at gmail.com> wrote:
> Heya List :)
>
> Any suggestion on the best way of makeing seperations in a panel using only the drillholes > available on the cheaper PCB services.  I was thinking of placing a bunch of .090" holes > .100" apart. Then it's a snap and file when the panel gets here.

Check with your PCB service to verify that they allow perforations
(and panelizing).
Some don't.

I usually draw silkscreen lines 100-150mils from the edge of the board and
use a bandsaw or a hacksaw.

(* jcl *)


-- 
http://www.luciani.org