gEDA-user: anyone has had success with 0.2mm?

[Ben Jackson]

On Mon, Dec 03, 2007 at 10:07:23AM -0800, Lope De Vega wrote:
> I'm trying to build a circuit with a cp2102, which has
> 0.5 mm between pins' center (actually 0.2mm between
> pins). It is a qfn-28 package.

Same spacing as QFP, which I've done successfully.  I didn't try to
toner-transfer it, though!

I did have my soldermask ganged by the manufacturer but I was still
able to put down a 208 pin QFP without bridges, just using lots of
flux.  I'm not sure how a home-etch board would fare.

FT232R would be easier to put down, I think.

-- 
Ben Jackson AD7GD
<ben at ben.com>
http://www.ben.com/