gEDA-user: 4-bit_12-LED.png (PNG Image, 1024x768 pixels)

[Svenn Are Bjerkem]

On 4/10/07, Ryan Seal <rseal at naic.edu> wrote:
>
> > A wire jump tells the reader _explicitely_ "Here are two wires
> > crossing". Two lines just crossing may trigger the question: "Are
> > these lines connected or not?".
> And a junction (circle or dot) doesn't do this???

A solder dot does _explicitely_ tell the reader that there is a
connection. The lack of a solder dot does not explicitely tell you
that there is a crossing as you can have two T-connections look like
an X-connection in your schematic viewer but the netlist (and pcb)
will show you something else). A wire jump shows an explicite
crossing. I think there must be some kind of misconseption of the use
of the words explicite and implicite in my original post. Sorry for
that.

-- 
Svenn