gEDA-user: 4-bit_12-LED.png

[Steven Michalske]

William,

Lines don't convey electrical connectivity, they are graphical elements.

You need to add nets for electrical connectivity.

When you draw nets, they will automatically connect the endpoints for  
you.

The N key will put you into net drawing mode.

Steve


On Apr 2, 2007, at 4:22 PM, william estrada wrote:

> OK, next stupid question,  How do I add a 'dot'?  Is this just a  
> small circle?
>
> -- 
> William Estrada
> MrUmunhum at popdial.com
> Mt-Umunhum-Wireless.net ( 64.124.13.3 )
>
>> Message: 10
>> Date: Mon, 2 Apr 2007 17:25:12 -0400
>> From: DJ Delorie <dj at delorie.com>
>> Subject: Re: gEDA-user: 4-bit_12-LED.png (PNG Image, 1024x768 pixels)
>> To: geda-user at moria.seul.org
>> Message-ID: <200704022125.l32LPCTc013221 at envy.delorie.com>
>> The rule is: Lines that cross without a dot are not connected.  Lines
>> that cross with a dot are connected.  No arcs are required.
>> A three-way connection is, obviously, connected.
>> Note: avoid connecting more than one net at the end of a pin; whether
>> you get a dot or not - and whether there's a connection between the
>> two nets or not - is ambiguous in that situation.
>> ------------------------------
>
>
>
> _______________________________________________
> geda-user mailing list
> geda-user at moria.seul.org
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user