gEDA-user: diagnosing toner transfer problems

[John Griessen]

I'd guess motion and time with heat smushed it.  My results were closer to the 
point of not enough heat, and required running bare board through my laminating 
heater several times to get good one last pass with toner transfer.

I did not run the toner attached paper through again, just once, after lots of 
heat soaking without it first.

John Griessen

DJ Delorie wrote:
  I'm mostly wondering about the smudged parts, like the
> board just above and left of center.  Too much heat?  Too much iron
> motion?  Some parts came out very crisp (like most of the board just
> below it).