gEDA-user: Re: Design changs required to mill PCBs?

[David Carr]

How did you get that pcbpool quote?
 I just got one for a 4 layer 50x50mm prototype and it was 143 euro 
which is way more than $104.  I'd love to get 4 layers for $100!

-DC

DJ Delorie wrote:
>> I always wanted one myself.  How that I've actually used it, I think
>> the funds could have been better used on test equipment.
>>     
>
> Yeah, I'm just drooling.  I'm a tool junkie.
>
>   
>>  It makes $33, http://www.33each.com , for a single two layer board
>> look cheap when you consider all of the time you have to put into
>> getting the boards produced.  Just wish someone would come out with
>> equivalent multilayer pricing.
>>     
>
> Unless prices have changed recently, the winners so far for 4 layer
> are (for 20 in2 m/s):
>
> qty1 : pcbpool $104 ea (6mil/12drill)
> qty3 : protoexpress $153/3 (6/15)
> qty5 : pcbex $158/5 (7/15)
>
> myropcb and pcbfabexpress are close to those.  After that it gets
> expensive.
>
>
> _______________________________________________
> geda-user mailing list
> geda-user at moria.seul.org
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
>