gEDA-dev: gerber importer/panelizer

[Erik Winn]

Hi again,

 BTW, I have just checked out gerbv 2.1-trunk - builds nicely (after a manual 
libtoolize ..) and looks great. And, it successfully imported a full panel 
(all layers) afterwards exporting it to what looks to my (only somewhat 
tutored) eye like legal rs274x. Very nice work. I would point out though that 
the G01 (linear interpolation) is usually omitted from the coordinates in 
most of the files I have dealt with - my understanding is that it is more of 
a reset command, I rarely see it (except from FreePCB and PADS). I don't know 
if this will cause problems (its perfectly legal according to all the specs I 
have been able to find), but I do know that it is rare.

Cheers,  
--
Erik Winn
BatchPCB.com
erik at batchpcb.com