gEDA-dev: PCB M4 libraries not hooked up right?

[Peter Clifton]

Hi,

I've just taken a poke at where I have used a TO92 like symbol before,
and I think it was from the texas instruments voltage regulator library.

texas_inst_voltage_reg.m4

I don't seem to have a ".list" file installed for that, yet there is one
in the built PCB source tree. It appears they been deliberately removed
from the installation.. I see the .list file under
"OBSOLETE_LIST_DIST_FILES" in the Makefile.am, even though the
corresponding .m4 file remains installed in M4_DIST_FILES.

Similarly, transistor.list is missing, so I can't get the TO92 etc...
with PCB's library browser.

Was this intended, or just a mistake?
-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)