gEDA-dev: Building pcb on cygwin from fresh CVS CO

[Bert Timmerman]

Peter, DJ, Dan,

I should have read the readme's before posting.

--enable-maintainer-mode did the trick although the build proces stumbles
upon an incomplete texinfo.tex and still bails out.

The compiled ./pcbtest.sh runs though.

Thx for the advise.

Kind regards,

Bert Timmerman.

-----Oorspronkelijk bericht-----
Van: geda-dev-bounces at moria.seul.org
[mailto:geda-dev-bounces at moria.seul.org] Namens Dan McMahill
Verzonden: donderdag 30 november 2006 16:57
Aan: gEDA developer mailing list
Onderwerp: Re: gEDA-dev: Building pcb on cygwin from fresh CVS CO

Timmerman, Bert wrote:
>  <<20061129_pcb-build.log.gz>> Hi all,
> 
> Last night I tried to configure/make pcb under cygwin from a fresh 
> check out from cvs (not an update).
> 
> IMHO it is missing "puller.txt", "thermal.txt", "puller.png"and 
> "thermal.png", complains about it and then bails out.
> 
> Gzipped log file included.
> 
> Kind regrds,
> 
> Bert Timmerman.

please read "README.cvs"

-Dan


_______________________________________________
geda-dev mailing list
geda-dev at moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-dev