Re: gEDA-dev: [patch] pcb: improved polygon rounded-corner rectangle support

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Wed, 2008-05-21 at 10:09 -0400, DJ Delorie wrote:
> > I do agree that a square mask cutout would allow slightly more
> > registration error, e.g. maximum offset in X _and_ Y directions
> > simultaneously, for little loss otherwise.
> 
> It sounds to me like the problem isn't the shape of the hole, it's the
> rotation of the hole.  I.e. a footprint rotated 45 degrees.

Ah yes.. insert brain before replying.

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-dev mailing list
geda-dev@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-dev