Re: gEDA-dev: gerber importer/panelizer

[Erik Winn <erik@xxxxxxxxxxxx>]

On Thursday 15 May 2008 06:58:20 pm Erik Winn wrote:
>  I definitely will. In fact, I have a question about output already - I was
> messing around with merging just using gerbv as a filter and ran into what
> _might_ be an error: the output includes a starting coordinate of X0Y0 at
> the very start. Here's an example:
>
> G04 --Start main section--*
> G01X00000Y00000D02*
> G54D11*
> G01X00394Y02344D02*
>
>  This actually broke the sizing on my web-parser as the board itself does
> not start there, but rather at the coordinate that comes right after the
> tool prepare (G54). So, I am wondering why the extra is there - I don't
> find this in any other output that I have tested the web parser against so
> far, so I am thinking that it is possibly a technically correct thing that
> nobody uses .. that might be omitted?

 In fact, now that I look more closely, it does this again a few lines later 
before another tool prepare - this was after I had merged an outline layer 
with a silk layer. I can send you the two files if you like Julian. The 
entire design is offset in both files.

--
Erik Winn
BatchPCB.com
erik@xxxxxxxxxxxx


_______________________________________________
geda-dev mailing list
geda-dev@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-dev