Re: gEDA-dev: pcb compile from cvs with docs question

To: john_g@xxxxxxxxxx, gEDA developer mailing list <geda-dev@xxxxxxxxxxxxxx>
Subject: Re: gEDA-dev: pcb compile from cvs with docs question
From: Dan McMahill <dan@xxxxxxxxxxxx>
Date: Tue, 25 Jul 2006 14:29:27 -0400
Delivered-to: archiver@seul.org
Delivered-to: geda-dev@moria.seul.org
Delivery-date: Tue, 08 Aug 2006 14:12:22 -0400
In-reply-to: <44C27CF2.9060704@cibolo.com>
List-archive: <http://www.seul.org/pipermail/geda-dev>
List-help: <mailto:geda-dev-request@moria.seul.org?subject=help>
List-id: gEDA developer mailing list <geda-dev.moria.seul.org>
List-post: <mailto:geda-dev@moria.seul.org>
List-subscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-dev>, <mailto:geda-dev-request@moria.seul.org?subject=subscribe>
List-unsubscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-dev>, <mailto:geda-dev-request@moria.seul.org?subject=unsubscribe>
References: <44C27CF2.9060704@cibolo.com>
Reply-to: gEDA developer mailing list <geda-dev@xxxxxxxxxxxxxx>
Sender: geda-dev-bounces@xxxxxxxxxxxxxx
User-agent: Mozilla/5.0 (X11; U; SunOS sun4u; en-US; rv:1.7.11) Gecko/20050802

John Griessen wrote:

Hi y'all,

I got a good compile of pcb without docs, so then I tried again adding the

--enable-maintainer-mode flag to ./configure

It goes and stops as below.

What is rule to make target `pcb.html', needed?

John G

What versions of automake and autoconf do you have? README.cvs gives some guidance as to what you need if you're tracking CVS sources.

-Dan

_______________________________________________
geda-dev mailing list
geda-dev@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-dev